Well, I finally got an emulator back up an running. I like VCC since it runs on XP/7 and I can still create REAL floppies with it. Since I finally have real CoCo hardware set up, it was time. An important note about VCC and the fdrawcmd utility - the documentation for VCC states it will not work with any version of fdrawcmd than 1.0.1.9, and that is a fact. 1.0.1.10 will not work with VCC, as I found out this week.
Hopefully, this week I'll get the sound system installed in the repack unit, and the I can work on the MPI. The repack has already been 6309'd, and I need to order a 512k kit from C9. After all of that is done, I need to wire up all of the CoCo's ports to be accessible from outside the case, AND, make the Atari j/s interface. Once all of this is done, tested and working, I get to clean up all the rough spots and then paint the case. Sounds easy, huh...
Later,
Brian
Blogging in 8-bits
1 comment:
Try replacing your current Vcc version of fd502.dll with this version: http://simonowen.com/fdrawcmd/fd502.dll
It removes the version check, so later versions of the driver will work.
Post a Comment